HP Z800 Sp632up SP632UPABA, FL939UT FL939UT#ABA manual Replicating the setup

Replicating the setup

This section provides information about replicating the workstation setup.

Copying a setup configuration to a single workstation

CAUTION: A setup configuration is model-specific. File system corruption can result if source and target workstations are not the same model.

To copy a setup configuration:

1.Select a setup configuration to copy, and then restart the workstation.

2.Power off the workstation you are configuring and insert the configuration diskette into the diskette drive or USB media device.

3.As soon as the workstation powers on, press and hold F10 until you enter the Computer Setup (F10) Utility. If necessary, press Enter to bypass the title screen.

NOTE: If you do not press F10 at the appropriate time, you must restart the workstation, and then press and hold F10 again to access the utility.

If you are using a PS/2 keyboard, you might see a keyboard error message. Disregard it.

4.Select File>Replicated Setup>Save to Removable Media. Follow the instructions on the screen to create the configuration diskette or USB media device.

5.Power on the workstation you are configuring.

6.Press and hold the F10 key until you enter the Computer Setup (F10) Utility. If necessary, press Enter to bypass the title screen.

7.Select File>Replicated Setup>Restore from Removable Media, and then follow the instructions on the screen.

8.Restart the workstation when the configuration is complete.

44 Chapter 4 System management ENWW