HP Z800 Sp632up SP632UPABA manual Right side panel, Power supply, Removing the right side panel

Right side panel

This section describes how to remove and install the right side panel.

Removing the right side panel

NOTE: Use this procedure to access the backplane wiring.

1.Disconnect power from the workstation (see Predisassembly procedures on page 73).

2.Remove the two T-15 Torx screws , and then slide the right side panel in the direction shown in the following figure until it stops, and then lift off the chassis 2.

Figure 5-10Removing the right side panel

Installing the right side panel

To install the panel, slide it into position on the workstation, and then fasten it with two T-15 Torx screws.

Power supply

This section describes how to remove and install a power supply.

Removing the power supply

1.Disconnect power from the workstation (see Predisassembly procedures on page 73).

2.Remove the side access panel (see Removing the side access panel on page 75).

80 Chapter 5 Replacing components ENWW