HP Z800 Sp632up SP632UPABA, FL939UT FL939UT#ABA manual Installing a PCIe card

Installing a PCIe card

1.Disconnect power from the workstation (see Predisassembly procedures on page 73).

2.Remove the side access panel (see Removing the side access panel on page 75).

3.Remove the expansion card support (see Removing the expansion card support on page 77).

4.Select the desired expansion card slot for the PCIe card. See Choosing an expansion card slot on page 146 for help in selecting a slot.

5.Raise the rear retention clamp by lifting the metal bar or the green lever as shown in the following figure .

Figure 5-95Removing the slot cover

TIP: Grasp the slot cover between two fingers—one from the inside of the chassis, and one from the outside.

6.Remove the PCI slot cover by pulling it up, out of the chassis 2.

148 Chapter 5 Replacing components ENWW