HP Z800 Sp632up SP632UPABA, FL939UT FL939UT#ABA manual Front panel I/O cable assembly

Front panel I/O cable assembly

This section describes how to remove and install a front panel I/O cable assembly.

Removing the front panel I/O cable assembly

1.Disconnect power from the workstation (seePredisassembly procedures on page 73 ).

2.Remove the side access panel (see Removing the side access panel on page 75).

3.Remove the expansion card support. (see Removing the expansion card support on page 77).

4.Remove the expansion card guide/front fan holder (see Removing the expansion card guide/front fan holder on page 126).

5.Remove the right side panel (see Removing the right side panel on page 80).

6.Remove the front bezel (see Removing the front bezel on page 85).

7.Disconnect the front panel I/O cable assembly cables from the system board as shown in the following figure.

Figure 5-16Disconnecting the front panel I/O cable assembly cables

Item Description

1Front audio

2Front 1394a

3Front USB

86 Chapter 5 Replacing components ENWW