Removing a hard disk drive from the slot load optical bay

1.Disconnect power from the workstation (see Predisassembly procedures on page 73).

2.Remove the side access panel (see Removing the side access panel on page 75).

3.Remove the airflow guide (see Removing the airflow guide on page 76).

4.Remove the expansion card support and any card cables that might interfere with slot load assembly removal.

5.Disconnect the optical drive power cable from the chassis power cable, and the optical drive data cable from the system board (see Removing the slot load optical disk drive on page 99).

6.Disconnect the slot load drive data cable from the system board connector as shown in the following figure.

Figure 5-45Disconnecting the data cable from the system board

7.Disconnect the chassis power cable from the slot load drive power connector as shown in the following figure.

Figure 5-46Disconnecting chassis power cable from hard disk drive connector

ENWW

Removing and installing components 111

Page 123
Image 123
HP FL939UT FL939UT#ABA, Z800 Sp632up SP632UPABA manual Removing a hard disk drive from the slot load optical bay