Removing a hard disk drive from the optical drive bay

1.Disconnect power from the workstation (see Predisassembly procedures on page 73).

2.Remove the side access panel (see Removing the side access panel on page 75).

3.Remove the airflow guide (see Removing the airflow guide on page 76).

4.Remove the expansion card support (see Removing the expansion card support on page 77).

5.Disconnect the power and data cables from the rear of the hard drive as shown in the following figure.

Figure 5-59Removing the power and data cables

6.Lift the drive release latch at the green touch point , and then slide the hard drive carrier from the chassis as shown in the following figure 2.

Figure 5-60Removing the drive from the ODD bay

ENWW

Removing and installing components 119

Page 131
Image 131
HP FL939UT FL939UT#ABA manual Removing a hard disk drive from the optical drive bay, 60Removing the drive from the ODD bay