HP FL939UT FL939UT#ABA manual Front bezel, Removing the front bezel, Installing the front bezel

Front bezel

This section describes how to remove and install the front bezel.

Removing the front bezel

1.Disconnect power from the workstation (see Predisassembly procedures on page 73).

2.Remove the side access panel (see Removing the side access panel on page 75).

3.Remove the right side panel (see Removing the right side panel on page 80).

4.Remove the four T-15 Torx screws , and then remove the bezel from the chassis as shown in the following figure 2.

Figure 5-15Removing the front bezel

Installing the front bezel

To install the front bezel, position the bezel on the chassis and install the screws.

ENWW Removing and installing components 85