HP Z800 Sp632up SP632UPABA, FL939UT FL939UT#ABA manual Removing a PCI card

PCI card

This section describes replacing a PCI card.

Removing a PCI card

1.Disconnect power from the workstation (see Predisassembly procedures on page 73).

2.Remove the side access panel (see Removing the side access panel on page 75).

3.Remove the expansion card support (see Removing the expansion card support on page 77).

4.Remove all cables connected to the PCI card.

5.Raise the rear retention clamp by lifting the metal bar or the green lever as shown in the following figure .

Figure 5-97Removing a PCI card

6.Lift the PCI card out of the chassis 2.

TIP: Store the card in an antistatic bag.

7.Install a PCI slot cover and close the expansion card retention clamp. The retention clamp is secured by the expansion card support.

NOTE: It is normal for the expansion card retention clamp to have a slight (5-10 degree) angle when closed. If the angle is greater than this, open the clamp and ensure that all cards are properly seated and all the brackets are mated to the chassis, then re-close the clamp.

150 Chapter 5 Replacing components ENWW