HP FL939UT FL939UT#ABA manual Expansion card support, Installing the airflow guide

Installing the airflow guide

1.Disconnect power from the workstation (see Predisassembly procedures on page 73).

2.Remove the side access panel (see Removing the side access panel on page 75).

3.Insert the airflow guide tabs into the rear chassis slots , and then lower the airflow guide until it clicks into place in the chassis 2 as shown in the following figure.

Figure 5-6Installing the airflow guide

4.Reinstall all removed components and reconnect any cables that have been disconnected.

Expansion card support

To prevent card movement during shipping, an expansion card support is installed. This section describes how to remove and install the expansion card support.

Removing the expansion card support

1.Disconnect power from the workstation (see Predisassembly procedures on page 73).

2.Remove the side access panel (see Removing the side access panel on page 75).

ENWW Removing and installing components 77