HP Z800 Sp632up SP632UPABA manual Installing an optical disk drive in the optical drive bay

Installing an optical disk drive in the optical drive bay

1.Disconnect power from the workstation (see Predisassembly procedures on page 73).

2.Remove the side access panel (see Removing the side access panel on page 75).

3.Remove the airflow guide (see Removing the airflow guide on page 76).

4.If you are adding an additional drive, remove the filler tray (see Removing a filler tray on page 91).

NOTE: Unused optical bay power cables are stored in this tray.

5.Lift and hold the drive release latch at the green touch point while sliding the optical disk drive into the bay 2. When the front of the drive is near its final position, release the latch, but continue to slide the drive inward until the latch closes and engages the drive.

TIP: An optical drive longer than 175 mm (but less than 206 mm) must be installed in the middle or bottom bay.

Figure 5-26Installing the optical disk drive

TIP: During installation the adjacent drive or filler may move slightly. You might have to slide and align both devices to get the release latch to close and engage both devices.

96 Chapter 5 Replacing components ENWW