HP Z800 Sp632up SP632UPABA, FL939UT FL939UT#ABA manual Expansion card guide/front fan holder

4.Connect one end of the data cable to the hard drive as shown in the following figure. Figure 5-71Connecting the data cables to the hard drives

5.Connect the opposite end of the data cable to the system board. Start with the lowest numbered port connector available on the system board.

NOTE: Repeat steps 2–4 for the second hard drive.

Expansion card guide/front fan holder

This section describes how to remove and install the expansion card guide/front fan holder.

Removing the expansion card guide/front fan holder

1.Disconnect power from the workstation (see Predisassembly procedures on page 73).

2.Remove the side access panel (see Removing the side access panel on page 75).

3.Remove the expansion card support (see Removing the expansion card support on page 77).

4.Remove the airflow guide (see Removing the airflow guide on page 76).

5.Remove expansion cards that are located in the card guide.

126 Chapter 5 Replacing components ENWW