HP Z800 Sp632up SP632UPABA manual Side access panel sensor optional, Installing the speaker

4.Disconnect the speaker cable from the inline front panel I/O cable , and slide the speaker from the chassis flanges 2 as shown in the following figure.

Figure 5-12Removing the speaker

Installing the speaker

To install the speaker, reverse the removal steps.

Side access panel sensor (optional)

The side access panel sensor is a switch that detects when the side access panel is opened. This section describes how to remove and install the side access panel sensor.

Removing the side access panel sensor

1.Disconnect power from the workstation (see Predisassembly procedures on page 73).

2.Remove the side access panel (see Removing the side access panel on page 75).

3.Remove the power supply from the chassis (see Removing the power supply on page 80).

82 Chapter 5 Replacing components ENWW