HP FL939UT FL939UT#ABA manual Installing dual SFF hard drives in the optical drive bay

Installing dual SFF hard drives in the optical drive bay

This section describes how to install two small form factor (SFF) hard drives in the workstation optical drive bay, and how to connect the hard drive cables.

Installing the hard drives

1.Disconnect power from the workstation (see Predisassembly procedures on page 73).

2.Remove the side access panel (see Removing the side access panel on page 75).

3.Remove the airflow guide (see Removing the airflow guide on page 76).

4.Remove the expansion card support (see Removing the expansion card support on page 77).

5.Remove the green rails from the bracket by squeezing the tabs and sliding the rails out of the bracket.

6.Orient the drive with the connectors on the rear of the drive facing toward the tabs on the bracket rails.

7.Gently open the rails as shown in the following figure. Figure 5-67Installing the drive in the rails

8.Lower the drive into the rails 2 as shown above. Align the four pins on the rails with the holes in the hard drive, and then snap the rails into place.

9.Carefully squeeze the green tabs while sliding the drive with rails into the drive bracket as shown in the following figure 2.

Figure 5-68Installing the drive in the optical bay bracket

ENWW Removing and installing components 123