HP FL939UT FL939UT#ABA, Z800 Sp632up SP632UPABA manual Screen message Probable cause

Table 6-10POST error messages (continued)

Screen message Probable cause Recommended action

518—Power supply wattage	Workstation configuration requires
insufficient for hardware	more power than the power supply can
configuration	provide.

●Reduce the workstation power consumption.

●Replace the power supply with a high output power supply.

601—Diskette Controller Error	Diskette controller circuitry or diskette	1.	Run the Computer Setup (F10) utility.
	drive circuitry incorrect.	2.	Verify cabling and replace defective cables if
			necessary.
		3.	Clear CMOS.
		4.	Replace the diskette drive.
		5.	Replace the system board.
605—Diskette Drive Type	Mismatch in drive type.	1.	Run the Computer Setup (F10) Utility.
Error		2.	Disconnect any other diskette controller devices
			(tape drives).
		3.	Clear the CMOS.
610—External Storage Device	External storage device is not	1.	Verify that the external device is present and
Failure	detected, is improperly connected, or		connected properly.
	is defective.	2.	Replace the external device.
611—Primary Floppy Port	The flexible disk drive is configured at	Select a new address for the flexible disk drive.
Address Assignment Conflict	a previously assigned address.
912—Computer Cover Has	N/A	No action required.
Been Removed Since Last
System Start Up
913—Front 1394 Not	Front 1394 device cable is	Reconnect the 1394 cable and restart.
Connected	disconnected from the system board.
916—Power Button Not	Power button cable is disconnected	Reconnect the cable and restart.
Connected	from the system board.
917—Front Audio Not	Front audio mechanism is missing or is	1.	Reconnect or replace the front audio cable.
Connected	not connected.	2.	Reconnect or replace the front audio mechanism.
918—Front USB Not	Front USB is missing or is not	1.	Reconnect the Front USB connector to the system
Connected	connected.		board.
		2.	Reconnect or replace the front USB mechanism.
920—Fatal error on QPI link X	Fatal error detected on QPI link x,	Potential system board problem; contact HP Support.
	where x is 0 or 1. This type of error is
	identified on the line following.
921—Fatal error on QPI	Fatal error detected in QPI link x	Potential system board problem; contact HP Support.
Protocol link X	protocol, where x is 0 or 1. This type of
	error is identified on the line following.
922—Fatal error on PCIe slot	Fatal error occurred in the designated	Move the card to a different slot. If the problem persists,
X	slot.	replace the card.
923—Fatal error on ESI port 0	A fatal error occurred on ESI port 0.	Verify that the ESI port device is connected and working
	slot.	properly.
924—Fatal error on IOH core	Fatal error detected on IOH core x,	Potential system board problem; contact HP Support.
X	where x is 0 or 1. This type of error is
	identified on the line following.

ENWW Diagnostic codes and errors 199