HP FL939UT FL939UT#ABA manual Installing a hard disk drive in the slot load optical bay

Installing a hard disk drive in the slot load optical bay

1.With power off and the workstation open, remove the expansion card support and any card cables that might interfere with slot load assembly installation.

2.Remove the slot load optical bay assembly. (See Removing the slot load optical disk drive on page 99 for details.)

3.Place the hard drive in the slot load carrier at an angle and push it into the carrier as shown in the following figure.

Figure 5-52Positioning the drive in the carrier

4.Rotate the hard drive flat, and adjust its position so the drive holes align with the carrier holes.

Fasten the drive in the carrier with the four Torx slotted screws supplied with the disk drive as shown in the following figure.

Figure 5-53Fasten the hard drive in the carrier

ENWW Removing and installing components 115