HP FL939UT FL939UT#ABA manual Installing a hard disk drive in the optical drive bay

Installing a hard disk drive in the optical drive bay

TIP: For optimum performance, install the hard disk drive in the bottom bay; do not install it in the top bay.

1.Disconnect power from the workstation (see Predisassembly procedures on page 73).

2.Remove the side access panel (see Removing the side access panel on page 75).

3.Remove the airflow guide (see Removing the airflow guide on page 76).

4.Remove the expansion card support (see Removing the expansion card support on page 77).

5.Carefully separate the carrier rails and set the drive between them, aligning the pins with the drive mounting holes.

Release the rails to secure the rails on the drive as shown in the following figure. Figure 5-63Installing the carrier rails

6.Slide the drive into the carrier until it snaps into place as shown in the following figure. Figure 5-64Installing the drive in the carrier

ENWW Removing and installing components 121