HP Z800 Sp632up SP632UPABA, FL939UT FL939UT#ABA manual Optical disk drive

Optical disk drive

This section describes how to remove and install an optical disk drive.

Removing an optical disk drive from the optical drive bay

1.Disconnect power from the workstation (see Predisassembly procedures on page 73).

2.Remove the side access panel (see Removing the side access panel on page 75).

3.Remove the airflow guide (see Removing the airflow guide on page 76).

4.Remove the expansion card support (see Removing the expansion card support on page 77).

5.Disconnect the power and data 2 cables from the optical disk drive as shown in the following figure.

Figure 5-24Disconnecting the optical disk drive cables

94 Chapter 5 Replacing components ENWW