14
CONVERTING FIREPLACE FROM NATURAL GAS TO PROPANE/LP GAS
Converting Control Valve
CONVERTING FIREPLACE FROM NATURAL GAS TO PROPANE/LP GAS
Continued
CONVERTING CONTROL VALVE
Convert the gas control valve by swapping out the valve regulator portion of the gas valve.
1.Using a TORX T20 or a slotted screwdriver, remove and dis- card the three mounting screws, pressure regulator tower, and diaphragm/spring components (see Figure 35).
2.Insure that the rubber gasket is properly positioned on the new pressure regulator assembly. Install new pressure regulator as- sembly to valve using new mounting screws supplied with kit. Tighten screws securely (approximately 25 in/lb). See Figure 36.
3.Install the identification label enclosed with gas valve regulator to the valve body where it can easily be seen (see Figure 36).
WARNING: The conversion kit must be installed by a qualified service technician in accordance with the manufacturers instructions and all applicable codes and requirements of the authority having juris- diction. If any information is these instructions is not followed correctly, a fire, explosion or production of carbon monoxide may result causing property dam- age, personal injury or loss of life. The qualified service technician is responsible for the proper in- stallation of this conversion kit.
Mounting | IH | OL | Pressure |
Screws |
|
| Regulator |
|
|
| |
|
|
| Tower |
Diaphragm/
Spring
Components
| OFF |
NO | P |
T |
OL
IH
| O | |
|
| FF |
NO |
| P |
T | I | |
Mounting
Screws
Rubber Gasket
Identification Label
Figure 36- Installing New Parts for Gas Control Valve Conversion
Figure 35 - Removing Parts for Gas Control Valve Conversion
For
.
.com
