Desa CDCFTP, CDCFTN, FDCFTN Installing Optional Blower Accessory GA3450TA, Removing Upper Louver

INSTALLATION

Optional Mantel Installation (Cont.) Installing Optioanl Blower Accessory GA3450TA

11

INSTALLATION

Continued

13.Check for leaks. See Checking Gas Connections, page 16.

14.Place mantel around fireplace. Be careful not to damage wall or mantel.

15.Place perimeter trim kit on the shoulder screws located on the side and top of the fireplace. Firmly snap trim over shoulder screws on fireplace (see Figure 12).

16.Adjust assembly to remove any gaps. Attach remaining two 3" wood screws from hardware pack through openings inside of fireplace sides into the mantel. The openings are located at top behind the area for top louver (see Figure 12).

17.Reinstall top louver.

Assembling Perimeter Trim (Perimeter trim shipped with mantel)

1.Remove packaging from three remaining pieces of trim.

2.Locate two adjusting plates with set screws, and two shims in the hardware packet.

3.Align shim under adjusting plate as shown in Figure 13.

4.Slide one end of adjusting plate/shim in slot on mitered edge of top brass trim (see Figure 13).

5.Slide other end of adjusting plate/shim in slot on mitered edge of side perimeter trim (see Figure 13).

6.While firmly holding edges of perimeter trim together, tighten both set screws on the adjusting plate with slotted screwdriver.

7.Repeat steps 1 through 6 for other corner.

8.Set perimeter trim assembly aside for later installation.

Set

Screws

Adjusting	Top Brass Trim
Plate	Slot
	Mitered Edge
Shim

Side Brass Trim

Figure 13 - Assembling Brass Trim

Shoulder Screw

Mantel

Base

Assembled

Brass Trim

Hole for 3" Wood Screw for Attaching Fireplace to Mantel

Gas Line

Access Hole

Shoulder

Screws

Hole for 3" Wood Screw for Attaching Fireplace to Wooden Base

INSTALLING OPTIONAL BLOWER ACCESSORY GA3450TA

Removing Upper Louver

To install the blower accessory, you must first remove the upper louver.

1.Lift screen off fireplace and remove log set if installed.

2.Remove 4 screws from upper louver (see Figure 11, page 10). Save these screws.

3.Pull upper louver straight out from the cabinet. Be careful not to scratch the paint. Set louver aside.

4.Open lower louver door by swinging door down (see Figure 11, page 10).

Figure 12 - Attaching Brass Trim to Fireplace

For morevisit www..com

111244-01A