Desa FDCFRP, CDCFTN, CDCFTP, FDCFTN, FDCFTP, FDCFRN, VDCFTP For Built-In Installation, Extension Cord

INSTALLATION

Installing Blower Accessory GA3450TA (Cont.)

13

INSTALLATION

Continued

For Built-In Installation

WARNING: A licensed electrician must connect the wiring harness to electrical supply following all local codes.Electricianmustprovideaclampontheboxcover to secure the wiring. Wiring should be routed through the bushing in the hole on the outer casing of fireplace.

1.Install snap bushing from blower kit into one hole on rear of re- mote/blower bracket (see Figure 17). The other hole is for a strain relief clamp (not supplied) to secure incoming electrical supply.

2.Follow steps 2 through 6 in Installing Blower Accessory, page 12.

	Fan Switch
	(Auto/Off/On)
		1 Auto
	Off	2
		3		Blue	Thermostat
			On			Switch
						(N.O.)
110/115			Red				Blue
V.A.C.							Blower
	Black							Motor
						Red
	White					White
	Green					Green

Figure 18 - Wiring Diagram For Blower Accessory Built-In Installation

3.A licensed electrician must follow the wiring diagram to connect incoming electrical supply to fan kit wiring harness (see Figure 18).

4.Plug power cord to outlet receptacle (not provided) as shown in Figure 17. Wind extra cable of power cord and tie up with plas- tic wire strap (see Figure 17). Set cable bundle between the re- mote/blower bracket and outer casing, away from the burner.

5.Test to make sure blower is working properly.

6.Reinstall upper louver beginning with bottom screws (see Fig- ure 11, page 10) and close lower louver.

Extension Cord

Use extension cord if needed. The cord must have a three-prong, grounding plug and a three-hole receptacle. Make sure cord is in good shape. It must be heavy enough to carry the current needed. An undersized cord will cause a drop in line voltage. This will result in loss of power and overheating. Use a No. 16 AWG cord for lengths less than 50 feet.

Blower Bracket

Assembly

Screw

Wire Harness

	Switch	Power Cord
Switch
		Outlet Receptacle
Plate
		(not included)

3 2 1

Blue Red

Black

Wire

Plastic Wire Harness

Strap

Lower Louver Door

Figure 17 - Installing Blower Bracket Assembly

I

H

	O
NO	FF

Clamp Connector (not included)

Remote/ Blower Bracket

For morevisit www..com

111244-01A