Vermont Casting 6000, 8000 owner manual Assembly Attach the Base to the Pillar, Tools Needed

Page 11

Assembly Step 2 - Attach the Base to the Pillar

Tools Needed:	locking
	caster

3/8”

wrench

7/16”

wrench

back side of base,

upside down

USE HARDWARE BAG A :

1/4-20 hex

nut (4)

1/4-20 x 3/4”

bolt (4)

LOCATE THESE PARTS:

pillar

assembly (1)

base assembly (1)

locking casters

back side of pillar,

upside down

1.Lock the pre-assembled casters on base by pushing down on the latch.

2.Set the pillar upside down.

3.Set the base upside down onto the pillar bottom as shown, aligning the holes in the base with holes in the pillar.

4.Insert the four bolts through the holes in the pillar and base. Thread the locking hex nuts onto bolts. Tighten the bolts and nuts with the wrenches.

5.Carefully turn the assembly upright onto the casters.

11

Image 11

Contents FormerlyNow Portable Gas GrillStatement of Commitment Formerly NowTable of Contents 6000, 8000 Series Gas Grill Portable L.P. Gas Barbecue Grills Fuel Regulator and Hose Transporting a Full Cylinder Filling and Purging Type 1 L.P. GAS Cylinders Take These Instructions to the L.P. Gas DealerAssembly Instructions Chapter Locate these parts Assembly Identifying the Grill PartsTools Needed Assembly Attach the Base to the PillarGrill bottom Assembly Heat Shield Back side of grill Assembly Attach Grill Bottom to PillarAssembly Step Assembly Attach the Side Tables USE Hardware BAG D Assembly Assemble the Grill LidAssembly Step No Tools are Needed Assembly Installing the Internal Grill PartsSet the warming rack onto the back of the cooking grids Installing an L.P. Gas Cylinder Connecting the Regulator to Cylinder Connecting the L.P. Gas CylinderFor specially equipped natural gas grills only Natural Gas Grills Connecting to Natural GasOperating the QUICK-CONNECT Parts Enclosed 6000, 8000 Series Replacement PartsSeries Parts Model 6000 Series ComponentsModel 8000 Series Components