Operating the QUICK-CONNECT

Natural Gas Grills - Connecting to Natural Gas

(for specially equipped natural gas grills only)

Follow all directions on tags attached to hose.

1.To connect the fuel-supply hose to the fuel supply, the shut-off valve must be closed.

2.Remove the dust cap from the connector socket by sliding the connector sleeve back to release the plug. Remove the dust cap from the plug.

Plug

3.Position the plug end of the fuel supply hose into the sleeve opening.

Connector Sleeve

4.Slide the connector sleeve back, firmly push the fitting into the connector.

Shut-off Valve

Dust Cap

5.Push the plug into the connector until the sleeve snaps forward to lock the fitting in place. Turn on the shut-off valve. The flow of gas to the appliance will be restricted if the plug is not connected properly.

6.Test for gas leaks using an ammonia-free soap and water solution.

TO DISCONNECT THE FUEL SUPPLY

1.Pull connector sleeve back and pull plug out of socket. This will automatically shut off gas to the appliance.

2.Close the shut-off valve and install the dust caps on the socket and plug. Always turn off the fuel supply at the shut-off valve when the grill is not in use.

LEAK TEST CONNECTIONS

Test all the fuel supply connections using an ammonia-free soap and water solution equally mixed. Never use fire to test for leaks.

1.Turn on the gas shut-off valve.

2.Coat all connections of the fuel supply system, especially at the quick-connect.

3.Watch for bubbles to indicate a leak.

4.If there is a leak, shut off the gas supply and re-connect the hose to the socket. Re-test for leaks.

Do not use the grill if a leak is detected that cannot be corrected in this manner or if the hose and connections become damaged. Replace damaged components with only factory authorized parts.

Do not strain or kink the fuel-supply hose. See that the hose is kept clear of surfaces that become hot during use.