Cleaning and Maintenance
Replacing Interior Halogen Canopy Lights
CAUTION
DISCONNECT THE ELECTRIC POWER BEFORE REPLACING BULB.
DO NOT touch bulb with bare hands. Clean off any signs of oil from the bulb and handle with a soft cloth.
Troubleshooting
| Problem | Possible cause and or remedy |
|
|
|
|
|
| Grill won’t light | Make sure the control knob is off (no gasis on). Remove |
|
| when the ignitor | the grill rack and the ceramic briquette trays. Watch the |
|
| is pressed | ignitor tip. You should see a spark jump from the tip of |
|
|
| the ignitor when the button is pressed. Do the other |
|
|
| burners work? Make sure the ignitor tip is clean and free |
|
|
| from debris. Check battery to electronic ignition. |
|
|
|
|
|
| Burner flame is | Check the burner inlet for obstructions. Check the air |
|
| yellow or orange | shutter for proper adjustment. |
|
1.Unsnap glass light cover using a screwdriver in the access groove.
2.Firmly grasp light bulb and pull out.
glass light
cover
access 
groove
and a gas odor |
|
is present |
|
|
|
Low heat with | Is the fuel hose bent or kinked? Is there adequate gas |
knob on | supply available? If only one burner appears low, does |
“HIGH” | the orifice or burner need cleaning? Are any other gas |
| appliances at the location below normal rate? Is the air |
| shutter too far open or closed? Is the gas supply or gas |
| pressure low? |
Product Care
3. Replace with halogen bulb using volt and wattage requirements listed on
glass cover.light
bulb
4. Replace the light cover by snapping glass cover onto metal box.
5. Reconnect power.
Spider Inspection
You should inspect the burners/venturi tubes at least once a year, or immediately if any of the following conditions occur.
•The smell of gas along with the burner flames appearing yellow.
•The grill does not reach the proper temperatures.
•The grill heats unevenly.
•The burners make a popping noise.
WARNING
SPIDER AND INSECT INFESTATION
Spiders and insects can nest in the burners/venturi tubes of this or any other grill, and cause the gas to flow from the front of the burner. This is a very dangerous condition that can cause a fire to occur behind the valve panel, thereby damaging the grill and making it unsafe to operate.
| Burner will not | Is there a spark at the thermocouple? Can you match |
|
| light | light the burner using the flame parts? |
|
|
|
|
|
| Burner lights, | Is the thermocouple kinked or bent away from the |
|
| but will not | burner? Readjust to lay flat against burner. Is the safety |
|
| hold flame once | valve button being depressed long enough? Hold button |
|
| button is | in until burner remains lit. Check for black spots on the |
|
| released | infrared screen. |
|
|
|
|
|
| If your grill | Is the electrical cord securely inserted in the electrical |
|
| rotisserie should | outlet? Is the circuit breaker open, or is a fuse blown? |
|
| fail to operate |
|
|
|
|
|
|
Product Care
30 | 31 |