Lighting Grill

Operation

100 Series Models

When lighting a burner, always pay close attention to what you are doing. Be certain you are pressing the battery ignition button corresponding to the burner you are lighting.

Electronic ignitor

Rotisserie control knob

NOTE: Control locations	Grill burner
will vary according to model.	control knob

Lighting Grill Burners

Open the hood or remove covers. Push and turn the control knob until the “HIGH” position on the knob aligns with the indicator line on the control panel. Press the electronic ignition button corresponding to the burner being lit. You will hear a clicking sound. Turn the control knob to the desired setting. If the burner does not light in 4 seconds, turn the knob to “OFF” and wait 5 minutes before trying again. This will allow accumulated gas to dissipate. After several failed attempts the burner can be lit with a paper book match using the flash tubes. If you have just attempted to light the burner with the ignitor, allow 5 minutes for any accumulated gas to dissipate.

Flash tube

Lighting Grill

Lighting Grill Burners with Flash Tubes

Place the lit match through the grid next to the flash tube of the burner being lit. Keep your face as far away from the grill as possible. Make sure the match is adjacent to the flash tube. Push and turn the control knob until the “HIGH” position on the knob aligns with the indicator line on the control panel. Make sure you are turning the control knob that corresponds with the burner being lit. If the burner does not light in 4 seconds, turn the knob to “OFF,” wait five minutes, and try again. If the burner will not light after several attempts, see the Troubleshooting section.

Lighting TruSear™ Infrared Burner (If Applicable)

Before lighting the burner, remove the stainless steel cover. Push in and turn the TruSear™ infrared control knob until the “HIGH” position on the knob aligns with the indicator line on the control panel. Once lit, turn the control knob to the desired setting. If the burner does not light within 4 seconds, release and turn the control knob to “OFF.” Wait 5 minutes for any accumulated gas to dissipate and try again. After several failed attempts, the burner may be lit by turning the control knob to “HIGH” and dropping a match on the face of the burner. If the burner does not immediately ignite, turn the knob to “OFF”, wait 5 minutes and try again.

Lighting the Grill Burners (300 and 500 Series Models)

Make sure the unit is plugged into a properly grounded receptacle. Turn the appropriate control knob counterclockwise to any position. This control is both a gas valve and an electric switch. Burners will ignite at any “ON” position with the automatic re-ignition system. If the flame goes out for any reason, the burners will automatically re-ignite if the gas is still flowing. When gas is permitted to flow to the burners, the electric igniters start sparking. On all surface igniters you should hear a clicking sound. If you do not, turn off the control and check that the unit is plugged in and that the fuse or circuit breaker is not blown or tripped.

Within a few moments, enough gas will have traveled to the burner to be able to light. When the burner lights, turn the burner control to any position to adjust the flame size. If the burner does not light in four seconds, turn the knob to “OFF” and wait 5 minutes before trying again. This will allow accumulated gas to dissipate. After several failed attempts the burner can be lit with a paper book match using the flash tubes.

Operation