Fiesta FG50057 manual Main Burners, Lighting

Page 10

LIGHTING

Prior to lighting yourbarbeque,visually check all hoses before each

use for nicks, cracking, abrasions or cuts. If the hose is found to be damaged in any way, DO NOT USE YOUR BARBEQUE. A replacement hose and regulator is required (see ‘PARTS LIST ’ in Assembly Brochure).

IMPORTANT

Always raise the barbeque lid before lighting.

Do not lean over the barbeque when lighting the burner.

Visually check the flames every time you light your barbeque (Figure 10). If the flame is abnormally small or a smoky yellow -- shut off the barbeque and check the venturi tubes for blockage (see Figure 8) or refer to the Troubleshooting Guide.

!

IF LIGHTING MAIN BURNERS ONLY,

 

CAUTION

ENSURE SIDE BURNER KNOB IS IN THE OFF

POSITION.

 

HIGH

LOW

Fig. 10

MAIN BURNERS

USING THE IGNITOR (Figure 11A)

1.Open the lid before lighting.

2.Turn off all of the burner control knobs and close the gas supply valve.

3.Open the gas supply valve and wait 5 seconds.

4.Push in and turn a single main burner control knob to ‘HIGH’.

All other control knobs should be in the "OFF" position. 5.Depress the ignitor, repeat if necessary.

6.If the burner does not light immediately (within five seconds), turn burner control knob off and wait 5 minutes to clear the gas.

7.Repeat steps 1 to 6. If burner still fails to light, refer to Troubleshooting Guide to determine cause and solution, or try the Match Lighting procedure (Fig. 11B).

1.

Fig. 11A

LIGHTING THE OTHER MAIN BURNERS

Once one burner has been lit, push in and turn the adjacent control knob to ‘HIGH’. The unlit burner will light automatically.

4.

5.

MATCH LIGHTING PROCEDURE

1.Open the lid before lighting.

2.Place an ignited lighter or lit match through the lighting hole, approx. 1.25 cm (1/2") from burner. (See Figure 11B)

3.Push in and turn the left burner control knob to ‘HIGH’. The burner should light immediately (within five seconds). If it does not, extinguish the lighter or match, turn the control knob to off, and wait 5 minutes to clear the gas.

4.Repeat steps 1 to 3. If burner fails to light, refer to the Troubleshooting Guide to determine cause and solution.

5.Once left hand burner is lit, light remaining burners in this sequence: center burner, then right burner.

LIGHTING THE OTHER MAIN BURNERS

Once one burner has been lit, push in and turn the adjacent control knob to ‘HIGH’. The unlit burner will light automatically.

BURNER

MATCH

MATCH

LIGHTING

HOLE

Fig. 11B

10

Image 10
Contents FG50057 If YOU Smell GASTable of Contents Safety SymbolsThank YOU for Purchasing this Barbeque Before YOU USE This Appliance InstallationApartment Dwellers Providing Power to Your Barbeque SafetyElectrical Caution Filling Transportation and StorageLP Cylinder Exchange Natural GAS Models Propane GAS ModelsPropane and Natural GAS Models What YOU’LL Need for Testing HOW to do the TestingPerform a Leak Test Storage Ignitor Battery Getting Familiar With the ControlsMain Burners LightingSide Burner Match Lighting Procedure Using the IgnitorBreaking in Your Barbeque RelightingShutting Down Your Barbeque Propane Models onlyCooking Techniques Internal Light Trouble Shooting Guide Conditions for Application of the Limited Warranty Year Platinum Limited WarrantyLimited Warranty Coverage Replacement or PRO-RATED RefundWheel Assembly Tools RequiredBase Cabinet Assembly Assembled ViewRear Panel Assembly ViewTrim Panel Assembly Front Door Assembly Casting Assembly Grill Assembly Side Shelf Assembly Side Burner Hose Assembly Grease Trap Assembly Providing Power to Your Barbeque StepTank Assembly HOSE/REGULATORBulb Replacement Instructions ALL Power to Grill Before Replacing LightDesignates Color BL=BLUE, B=BLACK, C=CHARCOAL Cover AssyDesignates Color BL=BLUE, B=BLACK, C=CHARCOAL Exploded Assembly