TANK ASSEMBLY
• Position tank into tank support as shown.
Assembled
View
Tank Not
Included
FIG.12
HOSE/REGULATOR
WARNING: Before proceeding with the following steps, ensure you have read: • L.P. Gas Cylinder • Hose and Regulator
Sections of the USE AND CARE INSTRUCTIONS located at the front of this manual. The L.P. gas cylinder, if supplied with your grill, has been shipped empty for safety reasons. The cylinder must be purged of air, and filled, prior to use. Follow all directions under "L.P. Gas Cylinder - Filling" section of the Use and Care Instructions.
Before attaching hose/regulator to tank, be sure cylinder valve and appliance valves are OFF.
The Q.C.C.1 cylinder valve has an internal back check module which will not allow gas to flow until a connection has been made.
The valve is turned off by rotating the handwheel (Fig. 3, Use and Care) Clockwise (left to right) until it stops. When attaching regulator to tank, make sure that the small probe (Fig. 13) in the nipple is centered in the mating Q.C.C.1 cylinder valve, turn the right hand threaded Q.C.C.1 nut onto the valve in a clockwise motion until there is a positive stop. DO NOT USE A WRENCH, HAND TIGHTEN ONLY.
FIG.13
HOSE/REGULATOR
| Q.C.C.I. NUT |
TANK | IMPORTANT: Ensure hose assembly |
| does not contact the casting, or any other |
| parts which will get hot. |
28