Thermos 461230404 manual Align holes Regulator hose

Page 7

3

This step requires two people to lift and position grill head onto cart.

Carefully lower the grill head onto the cart between the two braces. Align the two holes on each side of the grill head with the two holes on each brace. Make sure the regulator hose is hanging outside the cart.

Align holes

Regulator hose

4

Secure grill head to leg braces using four 1/4-20x3/4”screws (XX), 7mm lock washers (YY), and 7mm flat washers (ZZ). Screws must be attached from inside of grill head into brace.

Do not fully tighten screws until side shelf and sideburner shelf are assembled.

ZZ

YY

XX

461230404 • 7

Image 7

Contents 461230404 80001008 Safety Symbols Installation Safety PrecautionsTable of Contents Key Description Grill Lid Assembly 80001001 Cart AssemblyGrill Bottom Assembly 80001003 Side Shelf Assembly 80000059Parts Diagram Model No Assembly Model No Align holes Regulator hose Fully tighten screws inside grill bottom at this time #10-24x3/8 screws AAA, 5mm lock washers BBB Flametamer Pivot wire Smaller basket on left door, larger basket on right door Make sure drain hole is on left side Slide grease receptacle into rails beneath grease tray Very Important LP Liquefied Petroleum Gas LP Tank Removal, Transport And StorageLP Tank Filling LP Tank Leak Test Connecting Regulator To The LP TankFor your safety LP Tank ExchangeTurn all grill control knobs to OFF Leak Testing Valves, Hose and RegulatorFor Safe Use Of Your Grill And To Avoid Serious Injury Safety TipsIgnitor Lighting Match Lighting General Grill CleaningMatch-Lighting Ignitor Lighting The SideburnerWait for grill to cool Cleaning The Burner AssemblyStoring Your Grill Immediately turn off gas at LP tankIndirect Cooking Instructions Food SafetyHow To Tell If Meat Is Grilled Thoroughly Indirect CookingProblem Possible Cause Prevention/Solution TroubleshootingProblem Possible Cause Check Procedure Prevention/Solution Troubleshooting Electronic Ignition