Char-Broil 463250211 manual Upper back panel

Page 14

3

This step requires two people to lift and position grill head onto cart.

Untie regulator hose which is factory bundled underneath the grill head.

Carefully lower the grill head onto the cart, aligning slots at bottom of grill head with posts on cart side panels.

Make sure regulator hose is hanging inside the cart.

Grill head

Regulator hose

Right side panel

Left side panel

4

On back of grill, place upper back panel between side panels. Secure upper back panel, in lower holes, using one 1/4-20x1½”screw on each side.

Upper back panel

1/4-20x1½” screw

14

Image 14

Contents Estimated assembly time 30-40 minutes Date PurchasedTable of Contents This Grill is for Outdoor USE onlyInstallation Safety Precautions California PropositionLP Cylinder Filling USE and CareLP Liquefied Petroleum Gas LP Cylinder Leak Test For your safetyUseDo not household cleaning agents. Damage to gas Turn all grill control knobs to OFF Leak Testing Valves, Hose and RegulatorConnection, do not use this regulator For Safe Use of Your Grill and to Avoid Serious Injury Main Burner Ignitor LightingSideburner Match Lighting General Grill CleaningSideburner Ignitor Lighting Burner Flame CheckCleaning the Burner Assembly Storing Your GrillLimited Warranty Items Manufacturer will not PAY forParts List Key Qty DescriptionParts Diagram Assembly FrontUpper back panel Front Brace Foldable side shelf Flange into bracket Nut Cap Door Trough Replace the cap Troubleshooting Emergencies Possible Cause Prevention/SolutionAUTO-CLEAN Troubleshooting Electronic Ignition SectionPage Page Warranty Registration Department Box Columbus, GA