Char-Broil 463250211 manual Door

Page 19

11

Connect each of the wires from main burner electrodes into the back of the Electronic Ignition Module. Total (2) connections. Connect the two wires [(a) and (b)] from the switch wiring harness into the back of the Electronic Ignition Module.

Total (2) connections.

NOTE: Switch terminals are larger than electrode terminals and should only be installed in location shown as (a),(b).

(a)

1

2

(b)

12

Attach door handle to door using two #10-24x3/8”screws, 5mm lock washers and 5mm flat washers, shown A.

Insert hinge pin on bottom of door into hole in bottom shelf. Press upper hinge pin in front brace, align hinge hole on top of door, and release hinge pin into door.

A

	Door
	#10-24x3/8” screw
	5mm lock washer
	5mm flat washer	handle
	Door	handle
	Door

Door

PRESS

Top of door

Hinge pin on bottom of door

19

Image 19

Contents Date Purchased Estimated assembly time 30-40 minutesThis Grill is for Outdoor USE only Table of ContentsCalifornia Proposition Installation Safety PrecautionsLP Liquefied Petroleum Gas USE and CareLP Cylinder Filling UseDo not household cleaning agents. Damage to gas For your safetyLP Cylinder Leak Test Connection, do not use this regulator Leak Testing Valves, Hose and RegulatorTurn all grill control knobs to OFF Main Burner Ignitor Lighting For Safe Use of Your Grill and to Avoid Serious InjuryBurner Flame Check General Grill CleaningSideburner Ignitor Lighting Sideburner Match LightingStoring Your Grill Cleaning the Burner AssemblyItems Manufacturer will not PAY for Limited WarrantyKey Qty Description Parts ListParts Diagram Front AssemblyUpper back panel Front Brace Foldable side shelf Flange into bracket Nut Cap Door Trough Replace the cap Emergencies Possible Cause Prevention/Solution TroubleshootingAUTO-CLEAN Section Troubleshooting Electronic IgnitionPage Page Warranty Registration Department Box Columbus, GA