Char-Broil 463232011 manual Grill head Regulator hose

Page 14

3

Place lower back panel between side panels at rear of bottom shelf. Secure lower back panel to side panels using four 1/4-20x1/2”screws, 7mm lock washers, and 7mm flat washers on each side.

Lower back panel 1/4-20x1/2” screw

7mm lock washer 7mm flat washer

4

This step requires two people to lift and position grill head onto cart. Carefully lower the grill head onto the cart, aligning slots at bottom of grill head with posts on cart side panels. Make sure the regulator hose is hanging outside the cart. Grill head must face open side of cart.

Grill head

Regulator hose

14

Image 14

Contents Estimated assembly time 30 minutes Date PurchasedTable of Contents This Grill is for Outdoor USE onlyInstallation Safety Precautions California PropositionLP Cylinder Filling USE and CareLP Liquefied Petroleum Gas LP Cylinder Leak Test For your safetyUseDo not household cleaning agents. Damage to gas Turn all grill control knobs to OFF Leak Testing Valves, Hose and RegulatorConnection, do not use this regulator SDo not lean over grill while lighting For Safe Use of Your Grill and to Avoid Serious InjuryIgnitor Lighting Open lid during lightingSideburner Match Lighting General Grill CleaningSideburner Ignitor Lighting Burner Flame CheckVery Important Burner tubes must reengage valve Cleaning the Burner AssemblyStoring Your Grill Turn gas OFF at control knobs and LP cylinderLimited Warranty Items Manufacturer will not PAY for Parts List Key Qty DescriptionParts Diagram Assembly FrontGrill head Regulator hose Upper back panel Back of main control panel Now you may fully tighten lower screws on upper back panel Holes on fascia to Attach valve bracket Electrode Rear Wire Clarity of illustrationAssembled warming rack Grease tray Cylinder screw at rear of cart Troubleshooting Emergencies Possible Cause Prevention/SolutionAUTO-CLEAN Troubleshooting Electronic Ignition SectionPage Page Page Warranty Registration Department Box Columbus, GA