8
First, remove the two screws and lock washers factory attached to the sideburner valve bracket. Position sideburner valve bracket beneath sideburner shelf fascia so that valve stem comes through larger center hole in fascia. Align the holes on valve bracket with left and right holes on fascia. Secure using lock washers and screws that were removed from bracket.
Next, place sideburner bezel over valve stem on front side of fascia. Align small holes on bezel with upper and lower holes on fascia. Attach using two
Note: Use left and right
holes on fascia to
attach valve bracket
Screws and Washers removed from valve bracket
Install bezel with “OFF” at top.
Sideburner fascia
Sideburner valve bracket
24
Valve stem
Note: Use upper and lower
holes on fascia to
attach bezel
Control knob | |
|
4mm
lock washer
Control knob bezel
|
| Pull out the three knobs from control panel. Insert temperature gauge stem into the biger hole above knob bezel,shown A. | |
| 9 | ||
| Make the temperature gauge attached on the panel. Push the temperature gauge downward till it clips on the panel, | ||
| shown B/C. | Temperature gauge stem | |
|
| ||
|
|
| |
Temperature gauge
Knob bezel
Control panel
Knob
A
B
Back of the panel
C
18