Char-Broil 463232011 manual Back of main control panel

Page 16

6

Hang the four S hooks on towel bar. Attach towel bar to right side shelf using two 1/4-20x3/4”screws, 7mm lock washers and 7mm flat washers, shown A.

Insert flange on right side shelf into side shelf brackets on side of firebox, shown B.

Attach right side shelf using three 1/4”-20x3/4”screws, 7mm lock washers, 7mm flat washers, 1/4” nuts, shown C. Attach rear of shelf using one 1/4-20x1½”screw, 7mm lock washer, and 7mm flat washer in lower hole, shown D. Attach front of shelf and fascia using one #8x3/8” self-tapping screw and large flat washer, shown E.

Attach front of shelf and fascia using one 1/4”-20x3/4”screw, 7mm lock washer, 7mm flat washer and 1/4” nut, shown E/F .

 

 

 

 

A

S hook

Towel bar

7mm flat washer

7mm lock

washer 1/4-20x3/4” screw

Note: some parts omitted for clarity of illustration

C

1/4-20x3/4” screw

1/4”nut

 

7mm flat

 

 

washer

 

 

7mm lock

 

 

 

 

washer

 

 

E

#8x3/8” self-tapping screw

Large flat washer

1/4”nut 7mm lock washer

7mm flat washer

B

D

7mm flat

1/4-20x1½”

 

screw

washer

7mm lock

 

washer

F Back of main control panel

Igniter Switch

1/4-20x3/4”

screw

16

Image 16
Contents Estimated assembly time 30 minutes Date PurchasedTable of Contents This Grill is for Outdoor USE onlyInstallation Safety Precautions California PropositionLP Liquefied Petroleum Gas USE and CareLP Cylinder Filling UseDo not household cleaning agents. Damage to gas For your safetyLP Cylinder Leak Test Connection, do not use this regulator Leak Testing Valves, Hose and RegulatorTurn all grill control knobs to OFF For Safe Use of Your Grill and to Avoid Serious Injury Ignitor LightingSDo not lean over grill while lighting Open lid during lightingGeneral Grill Cleaning Sideburner Ignitor LightingSideburner Match Lighting Burner Flame CheckCleaning the Burner Assembly Storing Your GrillVery Important Burner tubes must reengage valve Turn gas OFF at control knobs and LP cylinderLimited Warranty Items Manufacturer will not PAY forParts List Key Qty DescriptionParts Diagram Assembly FrontGrill head Regulator hose Upper back panel Back of main control panel Now you may fully tighten lower screws on upper back panel Holes on fascia to Attach valve bracket Electrode Rear Wire Clarity of illustrationAssembled warming rack Grease tray Cylinder screw at rear of cart Troubleshooting Emergencies Possible Cause Prevention/SolutionAUTO-CLEAN Troubleshooting Electronic Ignition SectionPage Page Page Warranty Registration Department Box Columbus, GA