Char-Broil 463232011 manual Rear

Page 20

12

Insert front brace under control panel and between cart side panels. Make sure door hinge pins are on the top side and facing the front. Secure using two 1/4-20x1½”screws, 7mm lock washers, and 7mm flat washers on each side.

NOTE: MAKE SURE THAT THE FRONT BRACE IS MOUNTED IN THE MOST DOWNWARD POSITION WHEN ASSEMBLED TO CART.

Door

Hinge Pin

	7mm flat	7mm lock	1/4-20x1½”
Front brace	washer	washer	screw
Front brace

13

Inside of cart, insert rear shield tab into left slot on upper of lower back panel. Insert left and right grease tray rails into slots beneath grease tray opening in upper back panel, shown A. Attach front shield tabs under front brace and attach right and left rails under front brace with three #8x3/8” self-tapping screws, shown B.

	Tank heat shield
Rear	*This side UP
Rear

Front

Tank heat shield

Note: some parts omitted for clarity of illustration

B

Front Brace

A

Cart lower back panel

#8x3/8”

self-tapping screw

Right rail

Left rail

Left rail

Right rail

Tank heat shield

Grease tray opening

20

Image 20

Contents Estimated assembly time 30 minutes Date PurchasedTable of Contents This Grill is for Outdoor USE onlyInstallation Safety Precautions California PropositionLP Cylinder Filling USE and CareLP Liquefied Petroleum Gas LP Cylinder Leak Test For your safetyUseDo not household cleaning agents. Damage to gas Turn all grill control knobs to OFF Leak Testing Valves, Hose and RegulatorConnection, do not use this regulator For Safe Use of Your Grill and to Avoid Serious Injury Ignitor LightingSDo not lean over grill while lighting Open lid during lightingGeneral Grill Cleaning Sideburner Ignitor LightingSideburner Match Lighting Burner Flame CheckCleaning the Burner Assembly Storing Your GrillVery Important Burner tubes must reengage valve Turn gas OFF at control knobs and LP cylinderLimited Warranty Items Manufacturer will not PAY forParts List Key Qty DescriptionParts Diagram Assembly FrontGrill head Regulator hose Upper back panel Back of main control panel Now you may fully tighten lower screws on upper back panel Holes on fascia to Attach valve bracket Electrode Rear Wire Clarity of illustrationAssembled warming rack Grease tray Cylinder screw at rear of cart Troubleshooting Emergencies Possible Cause Prevention/SolutionAUTO-CLEAN Troubleshooting Electronic Ignition SectionPage Page Page Warranty Registration Department Box Columbus, GA