Char-Broil 463250510 manual Upper back panel

5

Insert front brace under control panel and between cart side panels. Make sure door hinge pins are on the top side and facing the front. Secure using two 1/4-20x1½”screws, 7mm lock washers, and 7mm flat washers on each side.

NOTE: MAKE SURE THAT THE FRONT BRACE IS MOUNTED IN THE MOST DOWNWARD POSITION WHEN ASSEMBLED TO CART.

Door

Hinge Pin

Front brace	7mm flat	7mm lock	1/4-20x1½”
	washer	washer	screw

Note: some parts omitted for clarity of illustration

6

On back of grill, place upper back panel between side panels and above lower back panel. Secure upper back panel, in lower holes, using one 1/4-20x1½”screw, 7mm lock washer, and 7mm flat washer on each side. Do not fully tighten screws until side shelf installation is complete in later steps.

1/4-20x1½”	7mm lock 7mm flat
screw	washer	washer

Upper back panel

15