Troubleshooting (continued)
Problem | Possible Cause | Prevention/Solution | |
|
|
| |
Burner(s) will not light | •Faulty electronic ignition circuit. | •See Troubleshooting Integrated Electronic Ignition section. | |
using ignitor. | •Sparking somewhere other than | •Inspect wire insulation and proper connections. Replace wires if | |
| |||
| between burner and electrode. | insulation is broken. | |
|
|
| |
Burner(s) will not | •See “GAS ISSUES:” on previous page. |
| |
match light. | •Improper method of | •See | |
| |||
|
|
| |
Sudden drop in gas | •Out of gas. | •Check for gas in LP tank. | |
flow or low flame. | •Excess flow valve tripped. | •Turn off knobs, wait 30 seconds and light grill. If flames are still low, | |
| |||
|
| turn off knobs and LP tank valve. Disconnect regulator. Reconnect | |
|
| regulator and | |
|
| then light grill. | |
| •Vapor lock at coupling nut/LP tank | •Turn off knobs and LP tank valve. Disconnect coupling nut from | |
| connection. | tank. Reconnect and retry. | |
|
|
| |
Flames blow out. | •High or gusting winds. | •Turn front of grill to face wind or increase flame height. | |
| •Low on LP gas. | •Refill LP tank. | |
| •Excess flow valve tripped. | •Refer to “Sudden drop in gas flow” above. | |
|
|
| |
•Grease buildup. | •Clean burners and inside of grill/firebox. | ||
| •Excessive fat in meat. | •Trim fat from meat before grilling. | |
| •Excessive cooking temperature. | •Adjust (lower) temperature accordingly. | |
|
|
| |
Persistent grease fire. | •Grease trapped by food buildup around | •Turn knobs to OFF. Turn gas off at LP tank. Leave lid in position and | |
| burner system. | let fire burn out. After grill cools, remove and clean all parts. | |
|
|
| |
Flashback... | •Burner and/or burner tubes are blocked. | •Turn knobs to OFF. Clean burner and/or burner tubes. See burner | |
(fire in burner tube(s)). |
| cleaning section of Use and Care manual. | |
|
|
| |
Unable to fill LP tank. | •Some dealers have older fill nozzles | •The worn nozzles don’t have enough “bite” to engage the valve. Try | |
| with worn threads. | a second LP dealer. | |
|
|
| |
One burner does not | •Grease buildup or food particles in | •Clean | |
light from other | |||
end(s) of carryover tube(s). |
| ||
burner(s). |
| ||
|
| ||
|
|
| |
| Possible Cause | Prevention/Solution | |
(If Equipped) | |||
|
| ||
Timer does not work | Dead Battery | Replace Batteries | |
(Green light does not | Batteries installed incorrectly. | Install batteries correctly. | |
flash) | Knob Position did not start the Clean | Push Knob in to start the clean cycle. (Green LED should begin to | |
| Cycle | flash) | |
|
|
| |
No LED’s will illuminate | Dead Battery | Replace Batteries | |
|
|
| |
Red LED next to battery | Low Battery Strength | Prepare to replace batteries (NOTE: Clean cycle will operate with | |
symbol is illuminated |
| a weak battery. | |
|
|
|
24