Ignitor Lighting
sDo not lean over grill while lighting.
1.Turn 
all burner control valves.
2.Turn on gas source or tank.
3.Open lid during lighting.
4. To ignite, turn LEFT knob to | . |
5.Push IGNITOR button rapidly.
6.If ignition does NOT occur in 5 seconds, turn the burner
controls 
, wait 5 minutes and repeat the lighting procedure.
7. To ignite right burner, turn right knob to | . |
If ignitor does not work, follow match lighting instructions.
After Lighting: Turn knobs to HI position for
CAUTION
If ignition does NOT occur in 5 seconds, turn the burner controls OFF, wait 5 minutes and repeat the lighting procedure. If the burner does not ignite with the valve open, gas will continue to flow out of the burner and could accidently ignite with risk of injury.
sDo not lean over grill while lighting.
1.Turn 
all burner control valves.
2.Open lid during lighting. Turn on gas at LP cylinder.
3.Place lit match into match holder, then into side of grill bottom (as shown below).
4. | Push in and turn LEFT knob to | . Be sure burner lights and | |||
| stays lit. |
|
|
| |
5. | To ignite right burner, turn right knob to | . |
| ||
After Lighting: Turn knobs to HI for |
|
| |||
|
|
|
|
|
|
|
|
|
|
|
|
Burner Flame Check
•Remove cooking grates and flame tamers. Light burners, rotate knobs from HI to LO. You should see a smaller flame in LO position than seen on HI. Always check flame prior to each use. If only low flame is seen refer to "Sudden drop or low flame" in the Troubleshooting Section.
HI
LO
Turning Grill Off
•Turn all knobs to OFF position. Turn LP cylinder off by turning
Ignitor Check
•Turn gas off at LP cylinder. Press ignitor button rapidly. "Click" should be heard and spark seen each time between collector box or burner and electrode. See "Troubleshooting" if no click or spark.
Valve Check
•Important: Make sure gas is off at LP cylinder before checking valves. Knobs lock in OFF position. To check valves, first push in knobs and release, knobs should spring back. If knobs do not spring back, replace valve assembly before using grill. Turn knobs to LO position then turn back to OFF position. Valves should turn smoothly.
Hose Check
•Before each use, check to see if hoses are cut or worn. Replace damaged hoses before using grill. Use only valve/hose/regulator specified by manufacturer.
General Grill Cleaning
•Do not mistake brown or black accumulation of grease and smoke for paint. Interiors of gas grills are not painted at the factory (and should never be painted). Apply a strong solution of detergent and water or use a grill cleaner with scrub brush on insides of grill lid and bottom. Rinse and allow to completely air dry. Do not apply a caustic grill/oven cleaner to painted surfaces.
•Plastic parts: Wash with warm soapy water and wipe dry.
useDo not citrisol, abrasive cleaners, degreasers or a concentrated grill cleaner on plastic parts. Damage to and failure of parts can result.
•Porcelain surfaces: Because of
•Painted surfaces: Wash with mild detergent or nonabrasive cleaner and warm soapy water. Wipe dry with a soft nonabrasive cloth.
•Cooking surfaces: If a bristle brush is used to clean any of the grill cooking surfaces, ensure no loose bristles remain on cooking surfaces prior to grilling. It is not recommended to clean cooking surfaces while grill is hot.
8 • 463666508