Cleaning the Burner Assembly

CAUTION

SPIDER ALERT!

SPIDER AND WEBS

INSIDE BURNER TUBE

If you notice that your grill is getting hard to light or that the flame isn’t as strong as it should be, take the time to check and clean the venturi’s.

VALVE

Follow these instructions to clean and/or replace parts of burner assembly or if you have trouble igniting grill.

1.Turn gas off at control knobs and LP cylinder.

2.Remove cooking grates and flame tamers.

3.Remove screws and carryover tubes from rear of burners.

4.Remove screw and washers to disengage burner from bracket on firebox.

5.Remove screws to detach electrode from burner. Electrode should remain in firebox.

6.Carefully lift each burner up and away from valve openings.

We suggest three ways to clean the burner tubes. Use the one easiest for you.

(A)	Bend a stiff wire (a light weight coat hanger works well)
	into a small hook. Run the hook through each burner
	tube several times.
(B)	Use a narrow bottle brush with a flexible handle (do not
	use a brass wire brush), run the brush through each
	burner tube several times.
(C)	Wear eye protection: Use an air hose to force air into

CONTROL PANEL

SPIDER WEBS

INSIDE VENTURI

the burner tube and out the burner ports. Check each

port to make sure air comes out each hole.

BURNER

In some areas of the country, spiders or small insects have been known to create “flashback” problems. The spiders spin webs, build nests and lay eggs in the grill’s venturi tube(s) obstructing the flow of gas to the burner. The backed-up gas can ignite in the venturi behind the control panel. This is known as a flashback and it can damage

7.	Wire brush entire outer surface of burner to remove food
	residue and dirt.
8.	Clean any blocked ports with a stiff wire such as an open
	paper clip.
9.	Check burner for damage, due to normal wear and corrosion
	some holes may become enlarged. If any large cracks or
	holes are found replace burner.

VERY IMPORTANT: Burner tubes must reengage valve

your grill and even cause injury.

To prevent flashbacks and ensure good performance the burner and venturi assembly should be removed from the grill and cleaned before use whenever the grill has been idle for an extended period.

openings. See illustrations at right.

10.Attach electrode to burner.

11.Carefully replace burners.

12.Attach burners to brackets on firebox.

13.Reposition carryover tubes and attach to burners. Replace flame tamers and cooking grates.

Correct

burner-to-valve

engagement

Storing Your Grill

• Clean cooking grates.

• Store in dry location.

• When LP cylinder is connected to grill, store outdoors in a well-

ventilated space and out of reach of children.

• Cover grill if stored outdoors. Choose from a variety of grill

covers offered by manufacturer.

• Store grill indoors ONLY if LP cylinder is turned off and

disconnected, removed from grill and stored outdoors.

		x
		bo
	e
r
Fi
			e
			b
			tu
		over
		y
		arr
		C

Firebox

• When removing grill from storage, follow “Cleaning the Burner

Assembly” instructions before starting grill.

burner bracket

Electrode

463271108 • 9

SPIDER ALERT!