Char-Broil 463271108 manual Left 7mm lock washer 7mm flat washer Right

Page 15

3

Place lower back panel between side panels at rear of bottom shelf. Make sure the slots are positioned as shown (A). Secure lower back panel to side panels using two 1/4-20x1/2”screws, 7mm lock washers, and 7mm flat washers on each side.

Lower back panel

Upside

 

1/4-20x1/2” screw

Left

7mm lock washer

7mm flat washer

Right

A

Downside

4

Insert wire ends into lower back panel (A). Attach front right side of wire shelf to the right side panel with one #8-32X3/8"screw, 4mm lock washer and 4mm flat washer (B). Leg attaches to bottom shelf with a #8-32X3/8"screw and a 4mm lock washer and 4mm flat washer (C).

B

A

C

5

This step requires two people to lift and position grill head onto cart.

Carefully lower the grill head onto the

 

cart, aligning slots at bottom of grill head

 

with posts on cart side panels. Make

 

sure the regulator hose is hanging

 

outside the cart. Grill head must face

 

open side of cart.

Grill head

Regulator hose

463271108 • 15

Image 15
Contents Model 463271108 Product Guide For residential use only. Do not use for commercial Call Grill Service Center for Help and PartsInstallation Safety Precautions Safety SymbolsTable of Contents Only LP cylinders equipped with this type of valve Device OPD. This OPD safetyLP Liquefied Petroleum Gas LP Cylinder FillingLP Cylinder Exchange Connecting Regulator to the LP CylinderFor your safety UseDo not household cleaning agents. Damage to gasLeak Testing Valves, Hose and Regulator Connection, do not use this regulatorTurn all grill control knobs to OFF Instructions For Safe Use of Your Grill and to Avoid Serious InjuryApartment Dwellers Ignitor LightingBurner Flame Check General Grill CleaningSideburner Ignitor Lighting Sideburner Match LightingVery Important Burner tubes must reengage valve Cleaning the Burner AssemblyStoring Your Grill Turn gas off at control knobs and LP cylinderHow To Tell If Meat Is Grilled Thoroughly Food SafetyStubborn Stains and Rust Routine Care Description Tools required for assembly Estimated assembly time KeyParts Diagram Model No Rear FrontLeft 7mm lock washer 7mm flat washer Right Installation is complete in later steps 7mm flat washer Val Front brace Tank Wire Press Cylinder screw at rear of cart Positioned them in the right directions Emergencies Possible Cause Prevention/Solution TroubleshootingElectronic Ignition Section Troubleshooting Electronic IgnitionBlank Intentionally Warranty Terms Limited WarrantyBlank Intentionally Please register your product online at Blank Intentionally Thank You for Your Purchase Grilling Safety Checklist