Philips Official Manual and Setup Guide for MX5100VR Home Theater System

MX5100VR.qxd 6/04/2004 3:37 PM Page 19

Before turning on your System, make sure batteries are in the remote control and the TV and System are connected correctly. You cannot program TV channels at the System if you are using a Cable Box or a Satellite Receiver.You will change channels at the Cable Box/Satellite Receiver.

1 Turn on the TV. Set it to channel 3 or 4 or its AUDIO/VIDEO IN channel, depending on how you connected the System to a TV.

2 light will appear on the front of the System.This display will

Press STANDBY-ONy to turn on the System, then

press VCR. The red VCR light and the red STANDBY-ON appear.￿￿ ￿￿￿￿

B ￿￿￿￿￿￿￿￿ ￿￿￿￿

These menus may not appear if you have already turned on the System (to find the Audio/Video In channel of the TV, for example). Follow the steps on page 28 to set up TV channels and page 32 to select a language for the VCR menus.

3 Press o or p to select English, French, or Spanish as the language￿￿￿￿￿￿￿￿￿for VCR on-screen displays and menus. Then, press B.

First-time Setup 19

1Turn on the TV.

STANDBY-ON

TIMER SET				2
SETUP/￿	AUDIO/￿	SUBTITLE	ANGLE
PROG	BAND
REC	DISPLAY		ZOOM
	C-RESET
SKIP/￿	CLEAR		SKIP/￿
CH			CH
TITLE	MODE/SPEED		RETURN
	TUNER
DVD			VCR	3-4
DISC
MENU			OK
STOP			PLAY
REW			FF
	PAUSE
			SLOW
1	2	3
			VCR/TV
4	5	6
		SEARCH MODE
7	8	9
		REPEAT	REPEAT
+10	0		A-B
SURROUND	SOUND	VOLUME

–￿ +

PHILIPS

4 Press B to begin channel programming. AUTO SETUP will flash on the TV screen during the channel search.The System will memorize all available channels.When channel programming is complete, the lowest available channel will appear on the TV.These channels will be available when you want to watch TV while the System is in VCR mode.To put the System in VCR mode, press VCR so the red VCR light appears. Use the SKIP i /CH o and SKIP j /CH p buttons to select memorized channels.To select non- memorized channels, use the Number buttons.

Helpful Hints

•To skip this feature and play a tape immediately, insert a tape with its record tab removed.

•To skip step 3, press DISC/MENU. VCR menus and displays will be in English.

•If you try to program channels when there is no antenna or Cable TV signal connected to the System’s TV ANTENNA IN jack, programming will stop. AUTO SET UP will stop flashing. Connect an antenna or Cable TV signal to the System’s TV ANTENNA IN jack and press B again.

•Repeat this process if the power fails for more than 30 seconds.

•To stop the Channel Setup while AUTO SET UP is flashing, press DISC/MENU.