Char-Broil 463269011 manual Assembly, 20x1/2 screws, 7mm lock washers

ASSEMBLY

1

Place bottom shelf upside down. Insert Bent U Pin into the caster mounting plate to lock it in place, shown A.

Spin the caster clockwise into the threads on the bottom shelf until secure. Remove the Bent U Pin and repeat for remaining casters. Make sure the two locking casters are secured at the rear and the non-locking casters are secured at the front. After all 4 casters are secure remove the Bent U Pin and save for future maintenance.

A

Non-lock caster

Bent U pin

Front

Locking caster

Bottom shelf

Rear

2	Attach side panels to bottom shelf using three
	1/4-20x1/2”screws, 7mm lock washers, and

7mm flat washers per panel.

IMPORTANT: Panel with magnet must be on left side of bottom shelf.

Left side panel

Magnet

Make sure side panels are pushed as far to the rear of bottom shelf as possible before fully tightening screws.

1/4-20x1/2” screw

7mm lock washer

7mm flat washer

Right side panel (with a hole)

Front

13