GE Monogram 24, 36, 48, 27 manual Stainless steel surfaces, Rotisserie, Burner cleaning

Page 26

Care and Cleaning

Stainless Steel Outdoor Cooking Center

Stainless steel surfaces

(on some models)

Do not use a steel wool pad; it will scratch the stainless steel surface.

Clean with hot soapy water. Rinse and dry.

If food soil remains, try a general kitchen cleaner, such as Fantastik®, Simple Green® or Formula 409®.

For hard to clean soil, use a standard stainless steel cleaner such as Bon-Ami® or Cameo®. Soils can also be soaked several hours with wet

towels. Apply cleaner with a damp sponge, rinse thoroughly and dry. Always scrub lightly in the direction of the grain.

After cleaning, use a stainless steel polish such as Stainless Steel Magic®, Revere Copper and Stainless Steeel Cleaner®, or Wenol All Purpose Metal Polish®. Follow the product instructions for cleaning the stainless steel surface.

Rotisserie

Keep the rotisserie motor electric cord away

Clean the skewer in warm sudsy water.

from the heated surface of the grill. When not

 

in use remove and store the motor in a dry

 

location.

 

Burner cleaning

Clean the exterior of the burner(s) with a wire brush.

Be sure burner ports are clear and free from debris. Clear any clogged ports with a straightened paper clip. Never use a wooden toothpick as it may break off and clog the port. Never enlarge the burner ports. Shake out any debris through the air shutter.

Use a flashlight to inspect the burner inlet to ensure it is not blocked. If obstructions can be seen, use a metal wire coat hanger that has been straightened out to clear them.

NOTE: To ensure warranty coverage and proper performance of the grill and range-top burners, monthly inspection and cleaning of all the grill and range-top burner orifices is recommended.

Grill burner for 27,″ 36and 48models

Grill burners for 24model

Orifice cleaning

Control panel and knobs

With the burner(s) removed, remove the

Use a needle to clear any debris. Be extremely

orifice and shine a flashlight through the

careful not to enlarge the hole or break off

opening to ensure there is no blockage.

the needle.

Clean up spatters with a damp cloth. Remove heavier soil with warm, soapy water.

Do not use abrasives of any kind on the control panel.

The control knobs may be removed for easier cleaning. To remove a knob, pull it straight off the stem. Wash the knobs in soap and water but do not soak.

26

Image 26
Contents Page Contents IntroductionSafety Precautions Write down the model Serial numbers Before using your cooking centerIf you need service If you received a damaged cooking centerImportant Safety Notice Safety Precautions Safety Precautions Design information On some modelsGeneral information Gourmet Radiant TraysBefore lighting the grill Lava rockCeramic briquettes To light the grill Allumage du gril RemarqueUsing the grill Grilling hintsGrilling guide Beets, carrots, turnipsFlame height Range-top burnersTo light a range-top burner Rotisserie system Maximum ″, 48 ″ modelsAssembly To load the skewer To setup the grill for rotisserieBasting pan To light the rotisserie burner Cooking timesSmoke flavor tray Wood chipsSmoker burner Smoker SystemTo light Lava rocks Grill components Care and CleaningDrip trays Burner grates Burner removal Replacing Rotary igniterSpider and insect warning 27, 36 and 48 Models Stainless steel surfaces Burner cleaningOrifice cleaning Control panel and knobs RotisserieQuestions? Use this problem solver Problem Solver Igniter is TurnedAccessories In-Home Repair ServiceService Contracts GE Answer CenterRegistration Ownership Product Consumer Consumer Product Ownership Registration What is Covered Warranty for customers in the USA
Related manuals
Manual 32 pages 48.67 Kb