GE Monogram 27, 36, 48, 24 Questions? Use this problem solver Problem Solver, Igniter is Turned

Page 27

Questions? Use this problem solver!

 

 

The Problem Solver

 

 

 

 

 

 

Stainless Steel Outdoor Cooking Center

 

 

 

 

 

 

PROBLEM

POSSIBLE CAUSE

 

 

 

 

 

 

GRILL WON’T LIGHT

•Check to see if other burners on the unit operate.

 

WHEN THE ROTARY

•Remove the grill rack and the stainless steel radiant tray, and watch

 

IGNITER IS TURNED

the igniter tip. You should see a spark jump from the tip of the igniter

 

 

 

 

when the knob is turned. If there is no spark check to ensure there is

 

 

gas supplied to the unit.

 

 

•Use a match to light the burner. (See the “To light the grill” section).

 

 

•Visually check the electrode and wire while turning the igniter.

 

 

The only place a spark should appear is at the electrode tip.

 

 

If the electrode or wire leaks voltage, remove and replace.

 

 

•Purge the gas line of any air.

 

 

•Check the orifice for blockage.

 

 

•Inspect the igniter tip to make sure it is clean and free from debris.

 

 

Clean the area. Readjust for 1/8″ gap.

 

 

 

 

 

 

BURNER FLAME IS

•Check the burner inlet for obstructions.

 

YELLOW OR ORANGE

•Check the air shutter for proper adjustment.

 

IN CONJUNCTION

(See the “Installation Instructions”).

 

WITH THE ODOR

 

•Placement of the cooking center is important for proper burner

 

OF GAS

 

operation. Do not place the cooking center in a dusty area.

 

 

 

 

 

 

 

LOW HEAT WITH

•Inspect the fuel hose to ensure it is not bent or kinked.

 

 

CONTROL KNOB IN

•Adequate gas supply may not be available. Check to make sure there

 

THE HI POSITION

 

is gas in the LP tank (on some models).

 

 

 

 

•If it is only one burner that appears low, the burner or burner orifice

 

 

may need cleaning.

 

 

•The air shutter may need adjustment.

 

 

•Preheat the grill for 15 minutes with the lid closed.

 

 

 

 

 

 

ROTISSERIE BURNER

•Check for a spark at the igniter.

 

WON’T LIGHT

•Use a match to light the burner.

 

(on some models)

 

 

 

 

 

 

 

 

 

 

OPTIONAL

•Readjust the thermocouple so that it is not bent or kinked, but

 

ROTISSERIE LIGHTS

lies flat against the burner.

 

BUT WILL NOT HOLD

•Hold the safety valve button in until the burner remains lit.

 

FLAME ONCE

 

 

 

 

BUTTON IS RELEASED

 

 

 

 

(on some models)

 

 

 

 

 

 

 

 

 

THE GRILL BURNER

•The burner may be upside down. Rotate the burner 180° and

 

WILL NOT SIT LEVEL

reinstall. Make sure it is secure and level.

 

INSIDE THE GRILL

 

 

 

 

BOX

 

 

 

 

 

 

 

 

27

Image 27
Contents Page Introduction ContentsSafety Precautions If you received a damaged cooking center Before using your cooking centerIf you need service Write down the model Serial numbersImportant Safety Notice Safety Precautions Safety Precautions On some models Design informationGourmet Radiant Trays General informationLava rock Ceramic briquettesBefore lighting the grill To light the grill Remarque Allumage du grilGrilling hints Using the grillBeets, carrots, turnips Grilling guideRange-top burners To light a range-top burnerFlame height Maximum ″, 48 ″ models Rotisserie systemAssembly To setup the grill for rotisserie Basting panTo load the skewer Cooking times To light the rotisserie burnerWood chips Smoke flavor traySmoker System To lightSmoker burner Grill components Care and Cleaning Drip traysLava rocks Burner grates Replacing Rotary igniter Spider and insect warningBurner removal 27, 36 and 48 Models Rotisserie Burner cleaningOrifice cleaning Control panel and knobs Stainless steel surfacesIgniter is Turned Questions? Use this problem solver Problem SolverGE Answer Center In-Home Repair ServiceService Contracts AccessoriesRegistration Ownership Product Consumer Consumer Product Ownership Registration What is Covered Warranty for customers in the USA
Related manuals
Manual 32 pages 48.67 Kb