Genesis Advanced Technologies Gas Grill manual Continue frame assembly, Install tubing plugs

Page 12

Continue frame assembly

You will need: leg frame, wheel frame, four 1/2 inch bolts, four nylon washers and a 7/16 inch or adjustable wrench.

Place the leg frame onto the tabs of the left frame. Place the wheel frame onto the tabs of the right frame. The leg tabs must be on the inside of the frames.

Add the washers to the bolts. Insert the bolts into the holes as shown, do not tighten bolts on wheel frame until a later step.

Install tubing plugs

You will need: two tubing plugs and a hammer. Insert tubing plugs into the ends of the leg frame. To fully seat the plugs, you may have to tap them lightly with a hammer.

Add Wrap-around Frame Panel

You will need: wrap around frame panel and a wrench. Place wrap-around frame panel in place:

1)The cut-out tabs should fit between the washer and the frame, as shown.

2)The square cut-out holes fit around the white plugs in the frame as shown

Tighten Bolts with wrench.

Turn the frame over and continue with assembly.

(1)

(2)

B-2

Image 12

Contents Gas Grill Liquid Propane GAS Units only Customer Service Center South Hicks RoadPalatine, IL Contents Gas Supply Testing For Installation in CanadaStorage OperatingGenesis Silver-A NG Page Page Page Page Assemble wheel frame Assemble frameContinue frame assembly Install tubing plugsAdd Wrap-around Frame Panel Add cooking box assembly Install manifold bracket Install frame connectorInstall Gas Supply General Specifications for Piping Install igniter Gas Line PipingTest Connections Check that all burner valves are off Connect flexible hose to manifoldPage Install the slide out bottom tray Install Lid Installing Features Install the left end trim pieceInstall the bottom shelf Installing the warming rackLighting To ExtinguishManual Lighting Failure to open lid while ignitingBarbecue’s burners, or not waiting 5 min Cleaning CookingStorage Cast Iron Cooking Grates Care Instructions Seasoning Cast Iron Grates a Solid vegetableAnnual Maintenance Do not use an open flame to check for gasLeaks. Be sure there are no sparks or open General Maintenance Main Burner Cleaning ProcedureMain Burner Flame Pattern Weber Spider Stopper GuardsReplacing Main Burners Positioned properly over the valve orifices2Crossover Ignition System Operations Flame is low when burner is on Burners burn with a yellow orOrange flame, in conjunction with Smell of gas