Genesis Advanced Technologies Gas Grill Installing Features, Install the left end trim piece

Page 20

Installing Features

Install the right trim piece with tool holders

Install the work surface

You will need: Right trim piece with tool holders

You will need: work surface.

Push the Right trim piece into the frame as shown(1),

Place the work surface, so that the front and back

making sure that the tabs on the underside of the trim

edges fit over the frame, in the area between the left

piece are snapped into the slots in the frame.(2)

trim piece and the cooking box as shown.

 

Do not use the work surface as a cutting board.

(1)

 

(1)

(2)

(1) Make sure that the tabs on the side table are to the right, next to the cooking box.

Install the left end trim piece

You will need: End trim piece, two 1/2 inch bolts, two nylon washers and a wrench

Slide the end trim piece into the frame as shown. Add washer to bolt and put through frame and hole in frame trim piece. Tighten with wrench.

C001.b

C-1

Image 20
Contents Gas Grill Liquid Propane GAS Units only Palatine, IL Customer Service CenterSouth Hicks Road Contents Gas Supply Testing For Installation in CanadaStorage OperatingGenesis Silver-A NG Page Page Page Page Assemble wheel frame Assemble frameAdd Wrap-around Frame Panel Continue frame assemblyInstall tubing plugs Add cooking box assembly Install Gas Supply General Specifications for Piping Install manifold bracketInstall frame connector Test Connections Install igniterGas Line Piping Check that all burner valves are off Connect flexible hose to manifoldPage Install the slide out bottom tray Install Lid Installing Features Install the left end trim pieceInstall the bottom shelf Installing the warming rackLighting To ExtinguishBarbecue’s burners, or not waiting 5 min Manual LightingFailure to open lid while igniting Storage CleaningCooking Cast Iron Cooking Grates Care Instructions Seasoning Cast Iron Grates a Solid vegetableLeaks. Be sure there are no sparks or open Annual MaintenanceDo not use an open flame to check for gas General Maintenance Main Burner Cleaning ProcedureMain Burner Flame Pattern Weber Spider Stopper GuardsReplacing Main Burners Positioned properly over the valve orifices2Crossover Ignition System Operations Flame is low when burner is on Burners burn with a yellow orOrange flame, in conjunction with Smell of gas