Holland BH421-AG4 manual Lower valance 2 ea, Casters 4 ea

❍On a flat surface (table or carport floor), OPEN AND EMPTY BOTH BOXES. REFER TO THE CONTENTS LIST TO BE SURE NO PARTS ARE MISSING. Tighten all factory installed fasteners that may have loosened during shipping.

Note: Use one lock washer per bolt, either under the hex nut or under the bolt head if a hex nut is not used.

E-3

Step 2.

Refer to Figure 2. Select the following parts for assembly:

3. casters (4 ea)

❍Attach magnetic catch to right cabinet side panel as shown in Figure 2a using 2 each 8-32 x 3/8 Phillips screws, nuts and lock washers.

❍Bolt the lower valance (2 ea) to the bottom front/rear of the cabinet side panels using the 1/4-20 x 5/8” hex head bolts and lock washers as shown in Figure 2b. Do not fully tighten them at this time.

❍Select the tank supports. Place the tank supports inside the cabinet and attach them to the backside of the lower valance as shown in Figure 2B. NOTE: They will attach toward the left side of the cabinet. Be sure the notches in the tank support bracket are up. Secure with 1/4-20 x 5/8” hex head bolts and lock washers. Check to make sure that the cabinet is square by measuring diagonally, before tightening any bolts. NOTE: Cabinet must be held square in order for the door to open and close properly. Tighten tank support bolts completely. Now go back and tighten lower valance bolts completely.

❍Place one each 3/8” flat washer onto the caster stud. Now screw caster into the lower valance corners. Tighten securely. Repeat for other 3 corners. NOTE: Locking casters go on the front. Lock the casters to prevent cabinet from moving around during assembly.