Nexgrill 720-0050-LP instruction

Rotisserie motor will not turn	--Check the voltage at the outlet.
	--If an extension cord is required, ensure it is a 16
	gauges, grounded cord.
	--Ensure the on/off switch is on.
	--Ensure the load does not exceed the 40 pounds
	operational capacity.
	--Ensure the spit is fully inserted in the motor.
	--Ensure there is no encumbrance or drag.

Grill only heats to 200-300 degrees.	--Ensure the temperature gauge is functioning
	properly. Hold a flame to the probe or compare
	the grill gauge to an oven thermometer place in
	the grill.
	--Ensure correct start procedure. Prior to lighting
	grill, the gas control knobs should be off. The
	propane bottle should be off. If not, wait 15
	minutes. Turn tank all the way on.. Turn left
	burner to ignite, wait 5 seconds ignite. Repeat for
	additional burners.
	--Check all gas connections for leaks with bubble
	test. If leaks are found, replace the part or tighten
	the fitting.

Grill takes a long time to preheat.	--Normal preheat 500-600degrees, takes	about
	10-15 min. Cold weather and wind may effect
	your preheat time.
	--If you are using volcanic rock or briquettes they
	can increase the preheat time and maximum
	temperature.

Burner flames are not light blue.	--Too much or not enough air mixes for the flame.
	--Elevation is the principal cause, however cold
	weather can affect the mixture.	Burner
	adjustment may be required. Refer to manual for
	adjustment procedures.
	--Grill is in a windy location.