Nexgrill 720-0050-LP manual Problem Solution

TROUBLE SHOOTING

PROBLEM	SOLUTION
When I light the grill it does not flame	--Make sure you have turn on the gas
immediately.	--Make sure it has spark while you are trying to
	ignite the burner.
	--Push in for approximately 5 second before to turn
	and ignite the grill.
	--Make sure your burner is clean.
Rotisseries burner will not light when	--Check to see if debris is blocking the electrode
the igniter button is pushed.	sparks.
	--Check to see there is spark that jumps to the
	burner from the electrode wire. If no spark is
	seen.
	--Check the battery located inside the button. Press
	and turn counter clockwise.
	--Check for loose wire connection.
	--Gently bend the electrode wire closer to the
	burner until a spark is seen to jump from the
	igniter to the burner when you press the starter
	button.
	--Dose the infrared back burner light when
	attempting to match light? If not, check did you
	turn on the gas.
Regulator makes noise.	--Vent hose on the regulator may be plugged or
	regulator may be faulty.
	--Ensure the vent hole on the regulator is not
	obstructed. Clear the hole, close the LP tank and
	gas control valves. Wait ten minutes and re-start.
	--When turning the LP tank valve on, do not cover
	vent hole on the regulator.
	--Check your flames for proper performance if the
	flames are not correct replace regulator.
Full size cover does not fit the grill.	--Cover may be incorrect for your grill. It may be a
	tight fit. Ensure the cover correct length for your
	grill. Measure it left to right. Compare to the grill’s
	measurement.
	--Compare the location and size of the hood portion
	of the cover to your grill.
	--Spread the cover and allow it to relax, preferably
	in warm sunlight or in a warm room.

18