Procom PL600HYLA, PN750HYLB, PN750HYLA, PL600HYLB installation manual Location, Safety Information

Page 3

SAFETY INFORMATION

THIS GASAPPLIANCE IS DESIGNED FOR OUTDOOR USE ONLY. IT IS NOT INTENDED FOR INSTALLATION IN ANY BUIDING, GARAGE.OR ENCLOSED STRUCTION. IT IS NOT INTENDED FOR INSTALLATIONINORONRECREATIONALVEHICLESORBOATS.

WARNING: Follow all gas leak procedures in this manual, prior to operation.

WARNING: Fuels used in gas fired appliances, and the products of combustion of such fuels, contain chemicals know to the State of California to cause cancer, birth defects and /or other reproductive harm. This warning is issued pursuant to California Health & Safety Code Sec.25249.1

While this appliance is not in use, the gas must be turned off at the gas supply.

While this appliance is not in use, it should be covered to protect it from weather and other adverse elements.

DO NOT ATTEMPT TO DISCONNECT THE GAS OR ANY GAS FITTING WHILE THISAPPLIANCE IS IN OPERATION.

Inspect the gas connections of this appliance prior to each use. Do not operate the unit if there is a gas leak present.

Do not put anything flammable, on or around or be- neath the campfire.

NEVER Leave the campfire unattended while in operation.

NEVER Allow children to operate this appliance. NEVER Lean over the campfire or place ,hand or fin- gers on the screen cover or near flame.

NEVER Use liquid propane gas in a natural gas unit, or natural gas in a liquid propane unit. Gas conver- sions SHOULD ONLY BE DONE BY A QUALIFIED SERVICE TECHNICIAN. DO NOT use charcoal bri- quettes or lighter fluid in any campfire.

Storage of this appliance indoors is permissible only if the gas is disconnected.

PROPER CLEARANCES FROM COMBUSTIBLE, CON- STRUCTION AND MATERIALS MUST BE MAINTAINED FROM ALL SIDES, TOP AND BOTTOM OF THIS APPLIANCE.

THIS APPLIANCE SHOULD NEVER BE PLACED ON ANY COMBUSTIBLE SURFACE.

THIS APPLIANCE SHOULD NEVER BE PLACED UNDER ANYCOMBUSTIBLE CONSTRUCTION OR MATERIALS.

THIS APPLIANCE SHOULD NEVER BE PLACED

CLOSER THAN FORTY-EIGHT (48”) INCHES FROM ANY SIDE TO ANY COMBUSTIBLE CONSTRUCTION OR MATERIALS.

Location

Your campfire can be installed on a flat, stable surface, away from any combustible materials or construction. (See FIgure 13)

Place unit on any level, outdoor, non combustible surface.

NOTE: Do not place this appliance on grass or dirt area , this may prevent proper venting.

HARD PIPING TO UNIT WITHOUT GAS PROXIMITY

1.TURN OFF THE GAS SUPPLY SYSTEM NOTE: All gas connections (except for brass to brass) require the following:

Clean pipe threads using either a wire brush or steel wool. Apply Teflon tape or pipe dope to the steel fittings before making any connection.

BE CAREFUL! Make sure all gas connections are snug, but not over tighten!

2.Extend the gas supply system using1/2” black iron pipe from current house supply. This may be ac- complished by a teeing off” or tapping into a con- venient gas line connection; installing the neces- sary pipe for the distance required; and then in- stalling a manual valve at exterior house wall. If pipe is to pass though a foundation or house wall, make sure to re-seal the area around the pipe with weather sealant.

3.From manual valve, extend piping to the campfire.

3

Image 3
Contents OWNER’S Operation and Installation Manual Table of Contents Location Safety InformationLocal Codes Location ContinueInstallation Installation continue Connecting to GAS Supply Operating HeaterFuel Requirements Lighting Instructions Maintenance and StorageProduct Features Service IndicationsReplacement Troubleshooting AccessoriesHigh Altitude Derate Parts List Parts Breakdown IllustratedPRO-COM TOLL- Free Number 1- 877- 886