Lighting Instructions

Off Position

Left

Rear

Centre

Right

Burner

WARNING! Open lid

WARNING! Ensure all burner controls are in the off position. Turn on the gas supply valve.

Main Tube Burner	Rear Burner Lighting	Side Burner Lighting
Lighting	(If equipped)	(If equipped)

1. Open grill lid.	1. Open grill lid.	1. Open/Remove side burner cover.

2. Push and turn any main burner	2. Remove the warming rack	2. Push and turn side burner control
knob slowly to the ’hi’ position. This		to high position.
action will ignite the pilot flame which
will in turn light the selected burner. If
the pilot lights, continue to push down
on the control knob until the burner
lights and then release.

3. If the pilot does not ignite, then	3. Clip a match into the supplied	3. Press and hold
immediately turn the control knob	lighting rod. Hold a lit match to	igniter button until burner lights, or
back to the ‘off position and repeat	right end ports of rear burner. Turn	light by match
step 1 several times.	rear burner to high.
.

4. If the pilot and burner will not		4. If the burner will not ignite within
ignite within 5 seconds, turn the		5 seconds, turn the control knob to
control knob to the ‘off’ position and		the ‘off’ position and wait 5 minutes
wait 5 minutes for any excess gas to		for any excess gas to dissipate. Either
dissipate. Either repeat steps 1 and 2		repeat steps 2 and 3 or light with a
or light with a match.		match.

WARNING! The propane cylinder is equipped with an excess flow device. Unless all burners are turned off prior to turning the cylinder on, only small flames and low heat will be achievable.

WARNING! Do not use the rear burner (rotisserie burner) with the main burners operating. WARNING! If lighting the unit with a match, clip the match into the supplied lighting rod.

Hold the lit match down through the grill and sear plate while turning the corresponding burner valve to high.