Napoleon Grills BGNV42P, BGNV42N manual LOG Placement, Charcoal Embers, Vermiculite, Charcoal Lumps

Page 9

LOG PLACEMENT

PHAZERTM logs and glowing embers, exclusive to Napo- leon Fireplaces, provide a unique and realistic glowing ef- fect that is different in every installation. Take the time to carefully position the glowing embers for a maximum glow- ing effect. Log colours may vary. During the initial use of the fireplace, the colours will become more uniform as colour pigments burn in during the heat activated curing process.

FIGURES19a-e

#1

#4

9

#5

4.Place the bottom of the left crossover log (#4) against the left outermost grate post and the top into the pocket provided on the back log. Position the notch located on the end of the center log (#5) against the middle grate post with the other end of the log resting in the pocket of the left crossover log.

1.Place the back log (#1) onto the log support tray and in front of the tabs. The tabs maintain an air space between the log and firebox back to facilitate combustion air flow. Ensure that the back of the log rests against the brackets on the back wall of the firebox.

#2#3

#6

5.Place the bottom of the right crossover log (#6) against the right outermost grate post and the top into the pocket provided on the center log (#5).

CHARCOAL EMBERS

2.Move the two small logs (#2 & #3) into position, lining up the studs located on the burner with the holes on the bottom of the logs.

Randomly place the charcoal embers along the front and sides of the log support tray in a realistic manner. Fine dust found in the bottom of the bag should not be used.

GLOWING EMBERS

3.Tear the glowing embers into pieces and place along the front row of ports covering all of the burner area in front of the small logs (#2 & #3). Care should be taken to shred the embers into thin, small irregular pieces as only the exposed edges of the fibre hairs will glow. The ember material will only glow when exposed to direct flame; however, care should be taken to not block the burner ports. Blocked burner ports can cause an incorrect flame pattern, carbon deposits and delayed ignition. PHAZERTM logs glow when exposed to direct flame.

VERMICULITE

Sprinkle vermiculite around the charcoal embers.

Note: Both charcoal embers and vermiculite are not to be placed on the burner.

CHARCOAL LUMPS

Place the lumps between the logs in a realistic manner taking care not to block any of the burner ports.

W415-0377 / 03.04.03

Image 9
Contents Millivolt System Table of Contents Napoleon GAS Fireplace Presidents Lifetime Limited Warranty General Instructions Care of GLASS, and Plated PartsGeneral Information Venting GAS Installation Framing InstallationMantle Clearances Nailing TAB InstallationDoor Installation Louvre Bracket InstallationL42 Louvre Installation GDL42 Louvre Installation Logo PlacementCharcoal Embers LOG PlacementVermiculite Charcoal LumpsOptional Blower Installation Thermostatic Sensor Control Optional FAN InstallationOperating Instructions Operation / MaintenanceMaintenance AdjustmentsPilot Burner Adjustment Venturi AdjustmentfigureReplacements Replacement PartsAccessories Symptom Problem Test Solution Trouble Shooting GuideDo not Clean Glass When HOT